Kia Clarus/Credos

1995-2001 of release

Repair and car operation



KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
- 11. АКП 50–40 LE
   11.1. Specifications
   11.2. Frictional mechanisms
   11.3. Blocking mechanism
   11.4. Search and determination of malfunctions
   11.5. Codes of malfunctions
   11.6. Diagnostic socket
   11.7. Postrepair operation
   11.8. Testing for delay time
   11.9. Testing of collaboration of an automatic transmission and the engine on the motionless car
   11.10. Testing of pressure of transmission liquid
   11.11. Testing for the pressure reduced by the valve
   11.12. Check of level and a liquid condition in an automatic transmission
   11.13. Situation sensor
   11.14. Switch of keeping of transfer
   11.15. Mode switch
   11.16. Switch of stoplights
   11.17. Sensor of temperature of transmission ATF liquid
   11.18. Check of resistance of the sensor of speed (day off)
   11.19. Check of resistance of the sensor of speed (entrance)
   11.20. Electromagnetic valves
   11.21. Replacement of a sealing ring of the sensor of temperature of transmission liquid
   11.22. Lateral casing of a transmission
   11.23. Sensor of speed (entrance and target)
   11.24. Valves of switching of transfer (No. 1, No. 2)
   11.25. Tubes of an oil radiator
   11.26. Dismantling and transmission assembly
   11.27. The note on dismantling
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits






11.22. Lateral casing of a transmission

PERFORMANCE ORDER
1. Turn out a drain stopper and merge transmission ATF liquid.
2. Unscrew bolts and remove a lateral casing.

Prevention

Be careful not to damage assembly sites of a casing.


3. Put hermetic (three bond 1281B) from the interior of openings for bolts of fastening of a casing.

Prevention

Clear a contact surface of a lateral casing.

The strip of hermetic should have width of 1,0-1,5 mm.

The knot is subject to assembly not later, than in 5 minutes after hermetic drawing.


4. Establish a lateral casing and fix bolts.

Inhaling moment: 20–29 N • m

5. Establish new laying and screw a drain stopper.

Inhaling moment: 24–55 N • m

6. Fill in transmission ATF liquid and check on absence of leaks from a lateral casing.