Kia Clarus/Credos

1995-2001 of release

Repair and car operation

KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
- 4. Cooling system
   4.1. Specifications
   4.2. Cooling liquid
   4.3. Check of tightness of system of cooling
   4.4. Replacement of cooling liquid
   4.5. Check of a cover of a radiator
   4.6. Radiator
   4.7. Water pump
   4.8. Thermostat
   4.9. Check of the fan of a radiator
   4.10. The sensor of temperature of cooling liquid
   4.11. Relay of the fan of a radiator
   4.12. Search and elimination of malfunctions
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits

4.6. Radiator


1–electric socket of the fan of a radiator;
2–electric socket of the fan of the condenser;
3–hoses of an oil radiator (AKP);
4–top and bottom hoses of a radiator;
5–radiator arm;
6–fan of a radiator and electric motor;
7–radiator fairing.


1. Disconnect a wire from the negative plug of the storage battery.
2. Remove a zabornik of fresh air.
3. Merge cooling liquid in the suitable container.
4. Remove a radiator in the following sequence:

– disconnect the electric socket from the radiator fan;
– disconnect the electric socket from the condenser fan (conditioner);
– disconnect hoses of an oil radiator (AKP);
– disconnect the top and bottom hoses of a radiator;
– remove a radiator arm;
– remove the fan of a radiator and the electric motor;
– remove a radiator fairing.


1. Check a radiator on lack of cracks, damages and leaks.
2. Check on lack of pognuty plates of a radiator. If necessary, using a hairbrush, straighten platinum.
3. Check a condition of entrance and target branch pipes of a radiator.


1. Installation is carried out to sequences, return to removal.


Establish a collar of fastening of a hose on the same place of a hose where it was before removal.

2. Fill in in cooling system necessary amount of demanded cooling liquid.
3. Start up the engine and check absence of leaks from cooling system.