Kia Clarus/Credos

1995-2001 of release

GENERAL INFORMATION

1–wheel;
2–dustproof cap;
3–the lock-nut to (replace);
4–support;
5–brake disk;
6–a nave with the bearing;

7–bolt;
8–brake board;
9–the sensor of frequency of rotation of a wheel (the cars equipped with anti-blocking system of brakes – ABS);
10-nave axis.

Nave of a back wheel

1–an ABS sensor rotor (the cars equipped with anti-blocking system of brakes – ABS);

2–nave bolt;
3–a nave with the bearing assembled.

Removal

PERFORMANCE ORDER

1. Lift the car and fix on support.

2. Turn out four nuts of fastening of a wheel.

3. Remove a wheel.

4. Remove a dustproof cap, unbend a fillet and unscrew a lock-nut.

5. Turn out two bolts and remove a support of a back brake.

6. Remove a brake disk.

7. Remove a nave with the bearing.

8. Turn out bolts and remove a brake board.

9. Turn out a bolt and remove the sensor of frequency of rotation of a wheel.

10. Disconnect two cross-section drafts and the longitudinal lever from a support of a back nave.

11. Weaken and then turn out two bolts of fastening of a rack of a back suspension bracket to a nave support.

12. Remove a nave support from a rack of a back suspension bracket.

Installation

PERFORMANCE ORDER

1. Check all details and, if necessary, repair or replace them.
2. Installation is carried out to sequences, return to removal, taking into account the following.
	3. Screw a new nut with a fillet and hammer a nut fillet into a nave groove. Inhaling moment: 176,6–235,4 N • m

Dismantling and assembly

PERFORMANCE ORDER

1. Remove from a nave an ABS sensor rotor.

2. A press with an opravka of the corresponding diameter squeeze out from a nave directing bolts of fastening of a wheel.

Prevention

The nave of a wheel is also external ring of the bearing of a back wheel therefore do not assort knot the nave / bearing.

3. Assembly is carried out in sequence, return dismantling.