Kia Clarus/Credos

1995-2001 of release

Repair and car operation


KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
- 12. Axes and power shafts
   12.1. Specifications
   12.2. Rotary fist and nave of a forward wheel
   12.3. Repair of a rotary fist
   12.4. Back suspension bracket
   12.5. Back axis
   12.6. Power shafts
   12.7. Right driving and intermediate shaft
   12.8. Dismantling and assembly of an intermediate shaft
   12.9. Left power shaft
   12.10. A power shaft with CV JOINTS of tripoidny type
   12.11. Search and elimination of malfunctions
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits





12.7. Right driving and intermediate shaft
GENERAL INFORMATION

1–wheel;
2–drain stopper;
3–stabilizer and stabilizer earring;
4–tip of steering draft; 		5–bottom spherical hinge;
6–right power shaft;
7–intermediate shaft.

Removal and installation
PERFORMANCE ORDER
1. Lift the car, fix on support and remove a forward wheel.
2. Turn out a nut of fastening of a power shaft to a nave of a forward wheel.
Prevention

When weakening a nut of fastening of a power shaft to a nave press a brake pedal to prevent provorachivany wheels and a power shaft.
3. Merge transmission liquid from a transmission.
4. Turn out a nut from each party and disconnect an earring of the stabilizer of cross-section stability.
5. Remove шплинт fixings of a nut of fastening of a tip of steering draft.
Prevention

Keen edges of a stripper can cut a dustproof cover of a tip of steering draft. Establish a stripper so that keen edges were between a dustproof cover and a rotary fist.
6. Unscrew a nut that it became aflush from the end of a spherical finger. By means of a stripper squeeze out a tip of steering draft from a rotary fist.
7. Turn out a coupling bolt of fastening of a finger of the spherical hinge of the bottom lever. Wrap up a rag dustproof consolidation of the spherical hinge and mount wring out the bottom lever down and separate a hinge pin from a rotary fist.
8. A kapron hammer beat out a power shaft from a nave of a forward wheel. If the power shaft densely sits in a nave of a forward wheel, spray propitochny aerosol solvent on area шлицов and then repeatedly screw a nut with a fillet so that it settled down flush with a shaft end face. Striking on a nut with a brass hammer, beat out a power shaft from a nave.
9. Reject outside a rotary fist and get a power shaft from a nave of a forward wheel.
10. Turn out bolts and remove a support of a power shaft from the block of cylinders of the engine and remove an intermediate shaft.
11. Installation is carried out to sequences, return to removal.
12. Fill in demanded amount of transmission oil of the specified type.
13. Freely screw nuts of fastening of an earring of the stabilizer, lower the car and, on the car standing on wheels, tighten nuts.