Kia Clarus/Credos

1995-2001 of release

GENERAL INFORMATION

1–шплинт;
2–nut;
3–steering draft and spherical hinge;

4–engine fastening;
5–returnable hose;
6–steering transfer and drive.

Removal of steering transfer is necessary for carrying out on the right side of the car.

PERFORMANCE ORDER

1. Weaken nuts of fastening of wheels.
2. Lift the car and fix it on support.
3. Remove wheels.
4. Take шплинт and unscrew a nut of fastening of a finger of the spherical hinge of a tip of steering bent for to a rotary fist. Turn on a nut until it will not reach the finger end.
	5. A stripper OK130 283 021 squeeze out a finger of the spherical hinge of a tip of steering draft from a rotary fist.
Prevention For an exception of damage of a carving of a pin screw on a carving a temporary nut. Do not tighten a nut strongly not to damage a carving.
6. Turn out a bolt connecting the universal hinge and a shaft of a gear wheel of steering transfer.
7. Merge liquid from a hydraulic drive of the amplifier of a steering.
8. Disconnect pressure head and returnable hoses from a case of steering transfer.
9. Turn out bolts of fastening of a case of steering transfer.
10. Move steering transfer and get it on the right side of the car.
Prevention At removal of steering transfer be careful not to damage protective covers.

Installation

PERFORMANCE ORDER

1. Installation is carried out to sequences, return to removal.
	2. Roll nuts of fastening of steering transfer in an order shown in drawing. Inhaling moment: 31–46 N • m
	3. Connect an intermediate shaft and a shaft of a gear wheel and fix a bolt, having tightened it the demanded moment. Inhaling moment: 18–27 N • m
4. After installation remove air from system of a steering and, if necessary, adjust a convergence.