Kia Clarus/Credos

1995-2001 of release

Repair and car operation


KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
- 17. Central air
   17.1. Specifications
   17.2. Check of drives of central air
   17.3. Connection of pipelines
   17.4. Quick disconnect connecting couplings
   17.5. Check of elements of central air located in salon of the car
   17.6. Removal and compressor installation
   17.7. Drive of management of modes
   17.8. Mixing drive
   17.9. Air inlet drive
   17.10. Channel sensor
   17.11. Compressor
   17.12. Magnetic coupling
   17.13. Two-regime relay of pressure
   17.14. Coolant (R–134A)
   17.15. Main data on service of system of cooling
   17.16. Search and elimination of malfunctions
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits





17.5. Check of elements of central air located in salon of the car

 Electric motor of the main fan
PERFORMANCE ORDER
1. Disconnect the socket from the electric motor of the main fan.
2. Check correctness of operation of the electric motor of the main fan when giving food on it (red contact: +, black contact:–).
3. In case of malfunction replace the electric motor.

Resistor
PERFORMANCE ORDER
1. Disconnect the socket from the resistor.
2. Check integrity of a chain and measure resistance between contacts.
3. Replace the resistor if it fused.
Prevention

Do not use the resistor repeatedly if fused a safety lock.


Termistor
PERFORMANCE ORDER
1. Check integrity of a chain between contacts.
2. At violation of integrity of a chain replace a termistor.
3. Check compliance of resistance between contacts to the following values:

Temperature (°C)
Resistance (kiloohm)
– 20
22,5–25,9
– 10
12,8–14,5
0
7,60–8,40
10
4,59–5,17
20
2,87–3,29
30
1,85–2,16
40
16,23–1,45

Evaporator
PERFORMANCE ORDER
1. Check an external surface of a core on existence of cracks or deformations.
2. At deformation of an edge of a core straighten it.
3. Check correctness of installation of a tube of a termistor.
Prevention

Check a sealing ring on existence of cracks and put on it cooling oil when the hose or a pipe will be connected to an entrance / target pipe of the evaporator. At replacement of a core of the evaporator on new through an entrance pipe enter in it about 50 cm3 of cooling oil.