Kia Clarus/Credos

1995-2001 of release

Repair and car operation

KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
- 11. АКП 50–40 LE
   11.1. Specifications
   11.2. Frictional mechanisms
   11.3. Blocking mechanism
   11.4. Search and determination of malfunctions
   11.5. Codes of malfunctions
   11.6. Diagnostic socket
   11.7. Postrepair operation
   11.8. Testing for delay time
   11.9. Testing of collaboration of an automatic transmission and the engine on the motionless car
   11.10. Testing of pressure of transmission liquid
   11.11. Testing for the pressure reduced by the valve
   11.12. Check of level and a liquid condition in an automatic transmission
   11.13. Situation sensor
   11.14. Switch of keeping of transfer
   11.15. Mode switch
   11.16. Switch of stoplights
   11.17. Sensor of temperature of transmission ATF liquid
   11.18. Check of resistance of the sensor of speed (day off)
   11.19. Check of resistance of the sensor of speed (entrance)
   11.20. Electromagnetic valves
   11.21. Replacement of a sealing ring of the sensor of temperature of transmission liquid
   11.22. Lateral casing of a transmission
   11.23. Sensor of speed (entrance and target)
   11.24. Valves of switching of transfer (No. 1, No. 2)
   11.25. Tubes of an oil radiator
   11.26. Dismantling and transmission assembly
   11.27. The note on dismantling
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits

11.14. Switch of keeping of transfer

Working capacity check

1. Check that the indicator KEEPING of TRANSFER turns on in that case when the switch TRANSFER KEEPING at the included ignition is pressed.
2. At misoperation check tension on contacts of the socket of the switch of keeping of transfer.

Tension check

1. Remove the back console.
2. Include ignition.
3. Check compliance of tension on G and N contacts to demanded values.
Tension on contacts
It is released Tension of the battery
It is pressed Less than 1,0 In
4. If tension on contacts differs from demanded values, check conductivity of a chain.

Check of conductivity of a chain

1. Disconnect the socket from the switch TRANSFER KEEPING.
2. Check conductivity of a chain between G and N contacts.

Conductivity of a chain
It is released x
It is pressed 0
3. At positive result check a chain, (from the switch TRANSFER KEEPING to the AKP control unit and from the switch TRANSFER KEEPING before connection with "weight").
4. At negative result of check replace knot of the lever of switching.