Kia Clarus/Credos

1995-2001 of release

Repair and car operation

KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
- 11. АКП 50–40 LE
   11.1. Specifications
   11.2. Frictional mechanisms
   11.3. Blocking mechanism
   11.4. Search and determination of malfunctions
   11.5. Codes of malfunctions
   11.6. Diagnostic socket
   11.7. Postrepair operation
   11.8. Testing for delay time
   11.9. Testing of collaboration of an automatic transmission and the engine on the motionless car
   11.10. Testing of pressure of transmission liquid
   11.11. Testing for the pressure reduced by the valve
   11.12. Check of level and a liquid condition in an automatic transmission
   11.13. Situation sensor
   11.14. Switch of keeping of transfer
   11.15. Mode switch
   11.16. Switch of stoplights
   11.17. Sensor of temperature of transmission ATF liquid
   11.18. Check of resistance of the sensor of speed (day off)
   11.19. Check of resistance of the sensor of speed (entrance)
   11.20. Electromagnetic valves
   11.21. Replacement of a sealing ring of the sensor of temperature of transmission liquid
   11.22. Lateral casing of a transmission
   11.23. Sensor of speed (entrance and target)
   11.24. Valves of switching of transfer (No. 1, No. 2)
   11.25. Tubes of an oil radiator
   11.26. Dismantling and transmission assembly
   11.27. The note on dismantling
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits

11.20. Electromagnetic valves

Check

PERFORMANCE ORDER

1. Disconnect the socket from the AKP electromagnetic valves.

2. Measure resistance between each contact and "weight".

Resistance:
valves No. 1, No. 2: 12–16 Ohm
valve of adjustment of pressure: 3,3–3,7 Ohm
blocking valve: 11–15 Ohm

Prevention

Valve No. 1 (switching 1–2,3–4): To

Valve No. 2 (switching 2–3): L

Blocking valve: J

Valve of adjustment of pressure: G, N

3. At discrepancy of values check existence of gaps or short circuits in wires. Replace valves.

Check of conductivity of a chain

PERFORMANCE ORDER

1. Disconnect the 26-contact socket from the AKP control unit.

2. Check conductivity of a chain between contacts of V, Y, Z and "weight" (valves No. 1, No. 2).

3. Check conductivity of a chain between contacts And and U (the valve of adjustment of pressure).

4. At negative results check existence of gaps or short circuits in wires.