Kia Clarus/Credos

1995-2001 of release

Repair and car operation


KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
- 11. АКП 50–40 LE
   11.1. Specifications
   11.2. Frictional mechanisms
   11.3. Blocking mechanism
   11.4. Search and determination of malfunctions
   11.5. Codes of malfunctions
   11.6. Diagnostic socket
   11.7. Postrepair operation
   11.8. Testing for delay time
   11.9. Testing of collaboration of an automatic transmission and the engine on the motionless car
   11.10. Testing of pressure of transmission liquid
   11.11. Testing for the pressure reduced by the valve
   11.12. Check of level and a liquid condition in an automatic transmission
   11.13. Situation sensor
   11.14. Switch of keeping of transfer
   11.15. Mode switch
   11.16. Switch of stoplights
   11.17. Sensor of temperature of transmission ATF liquid
   11.18. Check of resistance of the sensor of speed (day off)
   11.19. Check of resistance of the sensor of speed (entrance)
   11.20. Electromagnetic valves
   11.21. Replacement of a sealing ring of the sensor of temperature of transmission liquid
   11.22. Lateral casing of a transmission
   11.23. Sensor of speed (entrance and target)
   11.24. Valves of switching of transfer (No. 1, No. 2)
   11.25. Tubes of an oil radiator
   11.26. Dismantling and transmission assembly
   11.27. The note on dismantling
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits





11.25. Tubes of an oil radiator

 Check of a tube of an oil radiator on bends and deformation

PERFORMANCE ORDER
1. Check tubes of an oil radiator.

Check, on lack of excesses in places of curves.

Check, that the area of cross-section section of a tube did not become too small owing to its deformation because of superficial damages.
2. If necessary replace a tube of an oil radiator.

Tube obstruction

PERFORMANCE ORDER
Blow a tube through its inlet opening the compressed air under the pressure of 196,2 kPas and then check, whether can pass on it air under small pressure.
Prevention

At assembly of a tube of a radiator it is necessary to use a new sealing ring. Surely tighten a clip from a final opening.

If the tube of a radiator is damaged, the temperature of transmission ATF liquid will raise owing to reduction of its quantity in a radiator that can lead to violations in work and to leakages of oil from heat-removing tubes. Because the disconnected pressure of blocking of the converter of a torque cannot return to initial value, blocking remains, and the engine will stop idling.