| 1. Lift a jack a back part of the car and establish it on reliable support. |
| 2. Remove wheels. |
| 3. Removal carry out in the sequence shown in drawing. |
| 4. Check a condition of all details and, if necessary, repair or replace them. |
| 5. Installation is carried out to sequences, return to removal, taking into account the following. |
| 6. Put on an internal surface of the plug of the stabilizer konsistentny greasing for rubber. |
|
7. Establish the plug on an adjusting label on a stabilizer bar. |
| 8. Establish wheels. Inhaling moment: 88–118 N • m
|
Prevention
Having tightened a bolt of fastening of the stabilizer not up to the end, lower the car and finally tighten all bolts and nuts the demanded moments in not loaded condition.
|