Kia Clarus/Credos

1995-2001 of release

Repair and car operation

KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
- 15. Suspension bracket
   15.1. Specifications
   15.2. Adjustment of corners of installation of forward wheels
   15.3. Adjustment of corners of installation of back wheels
   15.4. A forward amortization rack with a spring
   15.5. Repair of an amortization rack of a forward suspension bracket
   15.6. Bottom lever of a forward suspension bracket
   15.7. Forward stabilizer of cross-section stability
   15.8. Draft of the forward stabilizer of cross-section stability
   15.9. Traverse
   15.10. Back amortization rack
   15.11. Repair of a back amortization rack
   15.12. Back stabilizer of cross-section stability
   15.13. Draft of the back stabilizer of cross-section stability
   15.14. Cross-section and longitudinal drafts
   15.15. Back cross-piece
   15.16. Search and elimination of malfunctions
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits

15.5. Repair of an amortization rack of a forward suspension bracket

GENERAL INFORMATION

Amortization rack

1–cover;
2–nut of fastening of a rod of the piston;
3–rubber element;
4–persistent bearing;
5–top basic plate of a spring;
6–top rubber basic ring of a spring;

7–dustproof casing;
8–course limiter;
9–twisted spring;
10-bottom rubber basic ring of a spring;
11-shock-absorber.

PERFORMANCE ORDER

1. Dismantling carry out in the sequence shown in drawing, taking into account the following.
2. Fix an amortization rack in a vice.
Prevention Close sponges of a vice plates from a soft material (copper plates).
3. Weaken a nut of fastening of a rod on two-three turns.
Prevention Do not turn out a nut completely.
	4. The special adaptation compress a spring of a rack of a forward suspension bracket.
5. Turn out a lock nut and remove a washer.
6. Remove a rubber element, the persistent bearing, the top basic plate of a spring, the top rubber basic ring of a spring, a dustproof casing, the course limiter, a twisted spring and the bottom rubber basic ring of a spring.
7. Check a condition of all details and, if necessary, repair or replace them.
8. Assembly carry out to sequences, return shown in drawing, taking into account the following.
9. Establish a twisted spring, having placed the spring end in a ledge of the bottom basic ring.
10. Establish the limiter of a forward stroke.