| 1. Lift a jack a back part of the car and establish it on reliable support. |
| 2. Remove wheels. |
| 3. Removal carry out in the sequence shown in drawing. |
| 4. Check a condition of all details and, if necessary, repair or replace them. |
| 5. Installation carry out to sequences, return to removal, taking into account the following. |
6. Establish wheels.
Inhaling moment: 88–118 N • m |
| 7. Having established a back cross-piece, measure parameters of adjustment of wheels and if necessary correct it. |
Prevention
Having fixed a bracket of the stabilizer and having tightened a bolt of cross-section draft not up to the end, lower the car and tighten all bolts and nuts the demanded moments in not loaded condition.
|