Kia Clarus/Credos

1995-2001 of release

Repair and car operation



KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
- 16. Body
   16.1. Cowl
   16.2. Trunk lid
   16.3. Front bumper
   16.4. Rear bumper
   16.5. Forward door
   16.6. Back door
   16.7. Screen wiper and stekloomyvatel of a windscreen
   16.8. Tank of a stekloomyvatel
   16.9. Windscreen
   16.10. Back glass
   16.11. Dashboard
   16.12. Sitting lobbies
   16.13. Back sitting
   16.14. Mechanism of an inclination of a back
   16.15. Seat belts
   16.16. External rear-view mirror
   16.17. An external rear-view mirror with the electric drive
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits





16.2. Trunk lid

GENERAL INFORMATION

1–safety lock of the lock of a trunk lid;
2–opening draft;
3–luggage carrier lock;
4–clamp of the cylinder of the lock;
5–cylinder of the lock of a luggage carrier;
6–conducting of the electric lock of a luggage carrier;
7–switch of the electric lock of a luggage carrier;
8–luggage carrier dampers;
9–luggage carrier loops;
10-luggage carrier panel;
11-rubber element;
12-luggage carrier sealant;
13-doggie of the lock of a luggage carrier.

Removal and installation

PERFORMANCE ORDER
1. Removal carry out in the sequence shown in drawing, taking into account the following.
2. Turn out bolts of fastening of a trunk lid and then uncover a luggage carrier.

Prevention

Removal of a trunk lid carry out with assistants.


3. Turn out bolts of fastening of the lock and take the trunk lid lock.
4. Disconnect unlocking cable and draft of a cover of the lock and remove the cover lock.
5. Check a condition of all details and, if necessary, repair or replace them.
6. Installation carry out to sequences, return to removal, taking into account the following.
7. At installation at first temporarily tighten bolts, and then tighten completely after adjustment of gaps.
8. Adjust the provision of a trunk lid, moving it in the extended openings for bolts of fastening of loops so that gaps on perimeter were uniform.
9. Weaken bolts and adjust the provision of a doggie of the lock of a trunk lid.