Kia Clarus/Credos

1995-2001 of release

Repair and car operation



KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
- 16. Body
   16.1. Cowl
   16.2. Trunk lid
   16.3. Front bumper
   16.4. Rear bumper
   16.5. Forward door
   16.6. Back door
   16.7. Screen wiper and stekloomyvatel of a windscreen
   16.8. Tank of a stekloomyvatel
   16.9. Windscreen
   16.10. Back glass
   16.11. Dashboard
   16.12. Sitting lobbies
   16.13. Back sitting
   16.14. Mechanism of an inclination of a back
   16.15. Seat belts
   16.16. External rear-view mirror
   16.17. An external rear-view mirror with the electric drive
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits





16.3. Front bumper

GENERAL INFORMATION

1–pallet;
2–front grille;
3–the bottom arm from a bumper;
4–obverse part of a bumper;
5–lateral plate of a bumper;
6–central arm of a bumper;
7–an energy absorber from the made foam material;
8–bumper fittings;
9–top arm of a bumper;
10-forward rack of a bumper;
11-fog light.

Removal

PERFORMANCE ORDER
1. Remove forward headlights.
2. Removal carry out in the sequence shown in drawing, taking into account the following.
3. Open a cowl and remove a front grille.
4. Remove a spring of the combined lamp and disconnect the socket of a plait of wires.
5. Remove the combined lamp.
6. Turn out adjusting bolts and disconnect the headlight socket.
7. Remove a headlight.
8. Turn out the top screws of fastening of a bumper and the bottom bolts on each side a bumper.
9. Turn out the screws shown in drawing by shooters, and remove the pallet.

10. Turn out bolts of fastening of a support of a bumper (are shown by shooters).
11. Remove a bumper assembled.

Adjustment

PERFORMANCE ORDER
1. After bumper removal assembled from a body remove the fixing details connecting facing of a bumper and fittings (are shown by shooters).
2. Remove the fixing elements attaching facing of a bumper to the lower part of a bumper (are shown by shooters).
3. Remove the bumper facing, power absorbing пеноматериал and fittings.
4. Check a condition of details.

Installation

PERFORMANCE ORDER
Installation is carried out to sequences, return to removal.

Prevention

At installation use new fixing elements

Inhaling moment: 16–24 N • m