Kia Clarus/Credos

1995-2001 of release

Repair and car operation



KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
+ 10. АКП G4A–EL
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
- 19. Brake system
   19.1. Specifications
   19.2. Pumping of hydraulic system of a drive of brakes
   19.3. Check of brake tubes and hoses
   19.4. Replacement of brake hoses
   19.5. Height of installation of a pedal of a brake
   19.6. Free wheeling of a pedal of a brake
   19.7. Distance of a pedal of a brake from a floor
   19.8. Brake pedal
   19.9. Check of the switch of a stoplight
   19.10. Main brake cylinder
   19.11. Check of the vacuum amplifier of brakes
   19.12. Forward disk brake
   19.13. Back disk brake
   19.14. Pressure regulator
   19.15. Parking brake
   19.16. Anti-blocking system of brakes (ABS)
   19.17. List of codes of malfunctions of brake system
   19.18. Precautions at carrying out repair
   19.19. Pumping of hydraulic system of a drive of brakes
   19.20. Hydraulic control unit (HCV)
   19.21. ABS control unit
   19.22. Sensors of frequency of rotation of a wheel
   19.23. Rotor of the forward sensor
   19.24. Main survey
   19.25. Check of functionality
   19.26. Search and elimination of malfunctions
+ 20. Electric circuits





19.22. Sensors of frequency of rotation of a wheel

GENERAL INFORMATION

FORWARD SENSOR OF FREQUENCY OF ROTATION OF THE WHEEL


Removal

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Remove a slip, then remove the sensor of frequency of rotation of a wheel and the socket.

Check

PERFORMANCE ORDER
1. Measure resistance of the sensor of frequency of rotation of a wheel.

Resistance: 1,0-1,3 kiloohms

2. Check sensor installation.

Gap: 0 mm

3. If necessary replace the sensor of frequency of rotation of a wheel.

Installation

PERFORMANCE ORDER
Installation is carried out to sequences, return to removal.

Prevention

For prevention of influence of hindrances on an entrance signal of the sensor of frequency of rotation of a wheel a sensor wire экранирован. After repair the wire should be placed in a starting position.



BACK SENSOR OF FREQUENCY OF ROTATION OF THE WHEEL


Removal


PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Remove back sitting and disconnect the socket of the sensor of frequency of rotation of a wheel.
3. Remove the sensor of frequency of rotation of a wheel.

Check

PERFORMANCE ORDER
1. Measure resistance of the sensor of frequency of rotation of a wheel.

Resistance: 1,0-1,3 kiloohms

2. Check sensor installation.

Gap: 0 mm

3. If necessary replace the sensor of frequency of rotation of a wheel.

Installation

PERFORMANCE ORDER
Installation is carried out to sequences, return to removal.

Prevention

For prevention of influence of hindrances on an entrance signal of the sensor of frequency of rotation of a wheel a sensor wire экранирован. After repair the wire should be placed in a starting position.