Kia Clarus/Credos

1995-2001 of release

Repair and car operation


KIA Klarus
1.1. Periodicity of maintenance
+ 2. FE DOHC engines and Т8 DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. Power supply system and release
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Mechanical transmission
- 10. АКП G4A–EL
   10.1. Specifications
   10.2. Search and determination of malfunctions
   10.3. Table of fast diagnostics
   10.4. Self-diagnostics system
   10.5. Codes of malfunctions
   10.6. Diagnostic socket
   10.7. Postrepair operation
   10.8. Testing of collaboration of an automatic transmission and the engine on the motionless car
   10.9. Testing for delay time
   10.10. Testing of pressure of transmission liquid
   10.11. Testing for the pressure reduced by the valve
   10.12. Check of level and a liquid condition in an automatic transmission
   10.13. Leakages of liquid from an automatic transmission
   10.14. Cable of a drive of a butterfly valve
   10.15. Mode switch
   10.16. Switch of stoplights
   10.17. Sensor of temperature of transmission ATF liquid
   10.18. Check of resistance of the generator of impulses
   10.19. Electromagnetic valves
   10.20. Removal of an automatic transmission
   10.21. General recommendations about transmission dismantling
   10.22. Dismantling of an automatic transmission
   10.23. Check and adjustment of preliminary loading of bearings
   10.24. Assembly of an automatic transmission
   10.25. Installation of an automatic transmission
   10.26. Oil radiator
   10.27. Driving disk
   10.28. Check of work and adjustment of position of the lever of the selector
   10.29. Selector lever
   10.30. Repair of the lever of the selector
+ 11. АКП 50–40 LE
+ 12. Axes and power shafts
+ 13. Steering
+ 14. Wheels and tires
+ 15. Suspension bracket
+ 16. Body
+ 17. Central air
+ 18. Electric equipment
+ 19. Brake system
+ 20. Electric circuits





10.29. Selector lever
GENERAL INFORMATION

1–forward console;
2–bolt;
3–nut;
4–selector lever; 		5–insulator;
6–clip;
7–spring pin;
8–selector cable.

Removal, check and installation

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the battery.
2. Removal of the lever of the selector carry out in the sequence shown in drawing.
3. Check a condition of details and, if necessary, repair or replace them.
4. Installation is carried out to sequences, return to removal.
5. Move the selector lever to a position P.
6. Pull a selector cable to its lever.
7. Press the selector lever against a position P and hold him in this situation.
8. Tighten bolts of fastening of a cable of the lever of the selector.

Inhaling moment: 7,9–10,7 N • m